Started flattening already. Plugin which I'm using is sometimes finicky, but it gets the job done, so I'll stick to it. Flattening should be straightforward, but time consuming - unfortunately I cannot do anything about this. After everything is flat, I'll do painting/test assembly, most likely in parallel, so I can adjust non-white elements accordingly, especially if position will matter.
This is only the base. Decided to split cylinder to 3 parts, as this generally makes cleaner assembly afterward. Some parts would be impossible to assembly as small boxes with 1mm height, so it's better to put them on 1mm cardboard and then to cut them. In test run I'll try 0,5 cardboard also, as this might look cleaner.
Best,
K.
No comments:
Post a Comment